Sweet Canoe & Kayak Loader

Featured

 

 

 

The SWEET Heavy-Duty Loader and Rack system is the perfect solution for loading and transporting canoes, fishing kayaks, touring kayaks, and SUPs.

The rotating rack allows a single person to load a canoe, long kayak, or SUP  on top of most SUVs, pickups, and cars.

The crossbars will accommodate loads up to  200 pounds and 35 1/2 inches wide.

The universal mounting plate attaches to all factory crossbars and to Thule and Yakima crossbars.

Quick-Release feature of the rotating rear rack allows you to install and remove the rack from its base, which can remain attached to the vehicle.

  • Heavy Duty powder-coated steel components
  • Stainless steel hardware
  • Precision welded and hand finished
  • Made in USA

 

Canoe Anchor and Drift System

Featured

An effective and easy to use canoe and kayak anchoring system is a mushroom style or a folding anchor that cna be stowed in a heavy-duty 2-gallon plastic bucket with holes drilled in the bottom. The bucket keeps the anchor and rope off the deck and out of the way, and the bucket also is a drift sock.

Mushroom-style anchors are less likely to get hung up on rocks or brush than folding anchors. This is important for safety when anchoring in deep water. Another good alternative for anchors are old window sash weights.

After dropping the anchor to hold the boat in place, tie the rope to a thwart using a half-hitch knot. The remainder of the rope stays in the bucket and out of the way. You can also toss the bucket overboard and tie of the rope off to use the bucket as a drift sock.

This system works well with the Sweet Anchor Board, which attaches to the bow or the stern and holds the anchor rope at the end of the canoe. This keeps the boat from swinging in the wind at anchor and also keeps the boat tracking straight when drift fishing.

The Anchor Board also balances the canoe when it is inverted and protects the ends of the canoe from damage.

Please order the Anchor Board using the Buy Online Pages.